Please note that the recommended version of Scilab is 2024.0.0. This page might be outdated.
See the recommended documentation of this function
Regular Output Port
This block represent a regular output port. It must only be used inside a Xcos Super Block and be connected to a regular output in the sub-system.
This block is a signal link from outside of a system into a sub-system. In a Super Block, the regular's output ports must be numbered from 1 to the total number of regular's output ports. You can set it with the Port number parameter.
Input : same type that the internal block connected to it in the sub-system.
An integer defining the port number.
Properties : Type 'vec' of size 1.
always active: no
- port 1 : size [-1,-2] / type -1
number/sizes of activation inputs: 0
number/sizes of activation outputs: 0
continuous-time state: no
discrete-time state: no
object discrete-time state: no
name of computational function: output
In the following example the Super block encloses two discontinuities. The OUT_f block is the non linear output signal.
The following figure shows the output of the bloc :
|Report an issue
|Port & Subsystem palette
|Signal processing palette >>