Please note that the recommended version of Scilab is 6.0.0. This page might be outdated.
See the recommended documentation of this function
Implicit Input port
This block represent an implicit input port. It must only be used inside a Xcos Super Block and be connected to an implicit input in the subsystem.
This block is a signal link from outside of a system into a sub-system. In a Super Block, the implicit's input ports must be numbered from 1 to the total number of implicit's input ports. You can set it with the Port number parameter.
Specify the port number of the input port.
Properties : Type 'vec' of size 1.
always active: no
- port 1 : size [-1,1] / type 1
number/sizes of activation inputs: 0
number/sizes of activation outputs: 0
continuous-time state: no
discrete-time state: no
object discrete-time state: no
name of computational function: inimpl
The following example shows the use of the INIMPL_f block. The Super block contains a simple electrical circuit with two inputs, one on the resistor and the other for the ground. These inputs are connected to the external environment of the bloc via two INIMPL_f blocks numbered 1 and 2. The Super block output is connected via a OUTIMPL_f block.
The following figure shows the output of the bloc :