Please note that the recommended version of Scilab is 2025.0.0. This page might be outdated.
See the recommended documentation of this function
OUTIMPL_f
Output implicit port
Block Screenshot
Contents
Palettes
Description
This block represents a regular implicit port. It must only be used inside a Xcos Super Block and be connected to an implicit output of an internal implicit output in the sub-system.
This block is a signal link from outside of a system into a sub-system. In a Super Block, the implicit's output ports must be numbered from 1 to the total number of implicit's output ports. You can set it with the Port number parameter.
Dialog box
Port number
An integer defining the port number.
Properties : Type 'vec' of size 1.
Default properties
always active: no
direct-feedthrough: no
zero-crossing: no
mode: no
regular inputs:
- port 1 : size [-1,1] / type 1
number/sizes of activation inputs: 0
number/sizes of activation outputs: 0
continuous-time state: no
discrete-time state: no
object discrete-time state: no
name of computational function: outimpl
Example
In the following example the Super block is a basic transistor switch. Open this example in Xcos .
The following figure shows the use of the Super block and the resulting output when its input is toggled between the potentials GND and Vcc. You can also see on the output the effect of the saturation voltage (minimal output = 0.4 Volt).
Interfacing function
| Report an issue | ||
| << IN_f | Port & Subsystem palette | OUT_f >> |