Please note that the recommended version of Scilab is 2025.0.0. This page might be outdated.
See the recommended documentation of this function
INIMPL_f
Implicit Input port
Block Screenshot
Contents
Palettes
Description
This block represent an implicit input port. It must only be used inside a Xcos Super Block and be connected to an implicit input in the subsystem.
This block is a signal link from outside of a system into a sub-system. In a Super Block, the implicit's input ports must be numbered from 1 to the total number of implicit's input ports. You can set it with the Port number parameter.
Dialog box
Port number
Specify the port number of the input port.
Properties : Type 'vec' of size 1.
Default properties
always active: no
direct-feedthrough: no
zero-crossing: no
mode: no
regular outputs:
- port 1 : size [-1,1] / type 1
number/sizes of activation inputs: 0
number/sizes of activation outputs: 0
continuous-time state: no
discrete-time state: no
object discrete-time state: no
name of computational function: inimpl
Exemple
The following example shows the use of the INIMPL_f block. The Super block contains a simple electrical circuit with two inputs, one on the resistor and the other for the ground. These inputs are connected to the external environment of the bloc via two INIMPL_f blocks numbered 1 and 2. The Super block output is connected via a OUTIMPL_f block.
The following figure shows the output of the bloc :
Interfacing function
SCI/modules/scicos_blocks/macros/Sources/INIMPL_f.sci
Report an issue | ||
<< CLKOUTV_f | Port & Subsystem palette | IN_f >> |